National Semiconductor Introduces Industry’s First 2A, Single Inductor, RGB LED Driver for Portable Projectors

10th June 2011
Posted By : ES Admin
National Semiconductor Introduces Industry’s First 2A, Single Inductor, RGB LED Driver for Portable Projectors
National Semiconductor introduced the industry’s first 2A red, green and blue (RGB) LED driver for portable projectors that drives three common anode RGB high-brightness LEDs sequentially with a single inductor. The highly-integrated LM3435 includes an I2C control interface for LED current control.
A basic portable or pocket projector LED design today includes a separate driver for each red, green and blue LED and each circuit requires an inductor. The design is bulky and costly, consisting of multiple components to accurately drive the LEDs. The growing popularity of pocket projectors, often smaller than a common two and a half inch portable hard drive, poses increased space constraints. A single LM3435 LED driver from National solves the problem by driving three RGB LEDs sequentially, powering one after another at 60 Hz and above to match the operation requirements of the latest liquid crystal on silicone (LCoS) or digital light processing (DLP) image devices. The much simpler, compact design requires just a single inductor and a few passive components alongside the driver.

National’s LM3435 LED driver joins National’s family of high-brightness projector drivers that include the LM3433 and LM3434 with high frequency dimming and LM3549 0.7A sequential-mode LED driver.

National will demonstrate the LM3435 in its booth A43 in Hall 8.1 at the Guangzhou International Lighting Exhibition in Guangzhou, China, June 9-12.

Technical Features of National’s LM3435 LED Driver
National’s LM3435 RGB LED driver is a highly-integrated, compact switching-mode constant current regulator that drives three LEDs in sequential-mode with a single inductor. The LM3435 integrates all active components, including an N-Channel main MOSFET, P-Channel synchronous MOSFET and three N-Channel pass switches for individual LED control. It accepts input voltage from 2.7V to 5.5V to drive constant current pulses to each red, green and blue high-brightness LED sequentially. The level of current pulses is individually programmed linearly for 1023 steps through an I2C interface. The maximum level of the current pulse can be set by three external current setting resistors to ground from 0.5A to 2.0A respectively. The non-isolated flyback converter with synchronous rectification ensures buck-boost operation at high efficiency.

You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

Sensor+Test 2019
25th June 2019
Germany Nürnberg Messe
DSEI 2019
10th September 2019
United Kingdom EXCEL, London
European Microwave Week 2019
29th September 2019
France Porte De Versailles Paris
Engineering Design Show 2019
16th October 2019
United Kingdom Ricoh Arena, Coventry
ELIV 2019
16th October 2019
Germany Bonn World Conference Center