SPD module designed for outdoor LED lighting protection

1st February 2018
Posted By : Lanna Cooper
SPD module designed for outdoor LED lighting protection

 

The LSP10GIHP series modules provide coordinated protection for most commercially available LED drivers used today, reducing driver failure more effectively than ever before. Lower clamping voltage and surge let-through current ensure greater luminaire protection.

These modules comply with ANSI C136.2-2015 Extreme, ANSI C82.77-5-2015 High Exposure, IEEE C62.41.2 Location Category C High Exposure, and US Dept. of Energy MSSLC Roadway Luminaire Elevated (20kV/10kA, 1.2/50μs-8/20μs) surge immunity standards.

A built-in thermal disconnect provides additional protection against catastrophic failure/fire hazard under varistor end-of-life or sustained overvoltage conditions.

Applications:

  • Roadway, street and traffic lighting
  • Parking garage lighting
  • Wash wall lighting
  • Digital signage
  • Tunnel lighting
  • Flood lighting

LSP10GIHP Series Surge Protection Modules provide robust surge protection for your outdoor/commercial LED lighting fixtures.

Features:

  • Low measured limiting voltage (MLV) and low voltage protection level (Up)
  • 20kA Maximum Discharge Current (Imax) 8/20µs
  • Meets US Department of Energy Municipal Solid State Street Lighting Consortium Specification
  • Meets ANSI C136.2-2015 Extreme Level and ANSIC82.77-5 Category C High (20kV, 10kA combination wave surge) requirements
  • UL 1449 and IEC 61643-11/ EN 61643-11 approved
  • Thermally protected
  • Double-insulated cable wire
  • IP66 rated
  • Series-connected design with built-in LED indication

Downloads


You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

SPIE Photonics Europe 2018
22nd April 2018
France Strasbourg